Flushing and Draining:
To flush or to drain the Everlast™ Series 2000 water heater, power must be
turned off and then turn off the cold water supply to the water heater. The
lever on the pressure and temperature relief valve should be opened but
care should be taken so the lever does not snap back as it could damage the
valve seat. The pressure in the water heater will be released when the lever
is opened.
The union at the cold water inlet to the water heater should be undone and a
hose should be attached to the water heater side of the union. The other end
of the hose should go to a drain.
Installations including a drain cock, as shown in inlet piping schedule, are
recommended as this allows for draining and for periodic flushing of the
water heater without piping disconnection at unions, and without the need for
rechecking for leaks after reconnection.
Opening the pressure and temperature relief valve allows air into the water
heater and for the water to drain. Following complete draining of the water
heater, the closest hot water taps may be opened fully and the pressure and
temperature relief valve closed with care. The cold water inlet stop valve
is now opened fully and the water heater may be filled with cold water and
flushed through to ensure the cylinder contains no sediment and is clean.
Finally the closest hot taps are closed and power may be turned on again
tothe completely filled water heater.
4 Warranty Conditions
1.
The system must be installed by a licensed plumber and/or
electrician in accordance with Everlast™ installation
instructions; and all relevant statutory and local requirements of
the State or Territory in which the system is installed.
2. The Everlast™ Series 2000 water heater must be operated and
maintained in accordance with instructions supplied by
Everlast™.
3.
This warranty only applies to the water heater product and does not
apply to any additional electrical and/or plumbing parts
supplied by the installer.
4.
The system is covered for the indicated period from the date of the
original purchase. Should a part of the complete water
heater component be replaced during this period, only the
balance of the original warranty will continue to remain effective.
Proof of purchase is required.
EVERLAST MANUAL 16pp.indd 11
9/07/10 11:02 AM
