26
For queries or additional product information, please call our Service Centre on:
087 997 0865
Please have your model name on hand.
www.everlastsa.co.za
Everlast/SA everlast_sa
CARE AND MAINTENANCE
PROCEDURES FOR LUBRICATING:
1. Use a soft, dry cloth to wipe the area between the belt and deck.
2. Spread lubricant onto the inside surface of the belt and deck evenly
MAKE SURE THE MACHINE IS TURNED
OFF AND POWER IS DISCONNECTED.
3. Lubricate the front and rear rollers to keep them at peak performance. If the treadmill belt/
deck/roller is kept reasonably clean it is possible to expect over 1200 hours before additional lubricating is
necessary.
BELT TRACKING ADJUSTMENT
This treadmill is designed to keep the belt reasonably centered while in use. It is normal for some belts to drift
towards one side while the belt is running with no one on it. After a few minutes of use, the belt should have a
tendency to center itself. If during use, the belt continues to move towards one side, adjustments are necessary.
• First, set treadmill to the lowest speed.
• Secondly, check which side the belt shifts too.
• If the belt shifts to right, tighten the right bolt and loosen the left bolt by using the Hexagonal Wrench, until the
belt is centered. If the belt shifts to the left, tighten the left bolt and loosen the right bolt by using the Hexagonal
Wrench, until the belt is centered.
damage to the mat.
BELT TENSION ADJUSTMENT
Belt tension adjustment is very important for joggers and runners in order to provide a smooth, steady running
surface. Adjustments must be made from the right and left rear roller using a Hexagonal Wrench. The adjustment
bolt is located at the end of the rails as noted in diagram below:
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt clockwise
and inspect for proper tension. When an adjustment is made to the belt tension, you must also make a tracking
adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - THIS WILL CAUSE BELT DAMAGE AND PREMATURE BEARING FAILURE.
Left bolt
Right bolt
• When adjusting the belt it is important to adjust the belt in half turn increments. Over adjusting the belt can cause
