99
100
9
For queries or additional product information, please call our Service Centre on:
087 997 0865
Please have your model name on hand.
www.everlast.com
MAINTENANCE
BELT ADJUSTMENT
If the treadmill belt is off center it should be stopped. Using the
5 mm Hex Wrench adjust the Screw in the Rear End Cap. If the
treadmill belt is moving towards the left side, tighten the left Hex
Screw about 1/4 turn
(clockwise). If the treadmill belt is moving towards the right side,
tighten the right Hex Screw about 1/4 turn (clockwise). Once the
adjustment is complete turn the treadmill on and observe the
treadmill belts position. If it is still incorrect repeat the same steps
until is moving in the center.
This action is very important, if the belt is not in the center, be sure
to follow above steps.
The position of the running belt might not stay precisely in the
center. It could run slightly towards the left or right sides, The
situation varies with how end-users use the equioment and the
weight of end-users.
Depending on the usage of the product, please apply Silicon (100)
on the board according to the below chart. Use the Hex Wrench to
unscrew the bolt inside the Rear Roller. Then pull the belt up and
daub some
SILICON to the center of the board. After that, adjust the belt to the
center of the deck, followed by tightening the screw to the original
set.
If the treadmill belt is slipping please follow the lubrication method
described above.
KGS/LBS
Speed
Time
KGS
6 KM/hr below
1 year
6~12 KM/hr
6 months
12 KM/hr above
3 months
LBS
4 mile/hr below
1 year
4~8 mile/hr
6 months
8 mile/hr above
3 months
Note: This maintenance is intended for household use.
If used for business, suggest one examine every other month.
