EverFocus PARAGON 264x4-16, Instruction Manual

Page: 60 / 134

54
Transparent: Alarm output keeps working according to the signal of alarm input.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: Time duration selectable from 1 to 150 seconds.
Matrix: Assign one of the 4 programmable monitor outputs (matrix outputs) to this alarm output (setup in
Monitor menu).
Monitor : Matrix monitor display options when an alarm occurs:
No change: No change on the matrix monitor display.
Spot: A full screen of the active camera will display on matrix monitor.
VGA Monitor: Monitor display options when an alarm occurs.
No change: No change on the main monitor display.
Full screen: A full screen of the active camera will display on main monitor.
Call Monitor: Monitor display options when an alarm occurs.
No change: No change on the call monitor display.
Full screen: A full screen of the active camera will display on call monitor.
HD Monitor: Monitor display options when an alarm occurs.
No change: No change on the HD monitor display.
Full screen: A full screen of the active camera will display on HD monitor.
Recording: Select which cameras will start recording when alarm happens.
Input Type: This field is to change the type of alarm trigger.
N.O.: Normal Open contact.
N.C.: Normal Close contact.
Active Camera: This field is for assigning the alarm to a specific camera. For example if you had an
external motion detector on camera one you would set this option to “1”.
PTZ Preset: Select PTZ Preset from “1” to “255”. If the Active Camera is a PTZ speed dome, the alarm will
move the camera to the specified preset position for event recording. Click “Done” to confirm selection,
“Cancel” to cancel selection.
Apply To: This button can be used to copy the alarm settings to other cameras. Select which cameras you
wish to copy to. "Select All" selects all cameras, “Unselect All” deselects all cameras. Click “OK” to copy the
settings or "Cancel" to exit without copying.