EQ610s
15
•
D/N IN
mode must be selected if the camera receives its Day/Night
mode-change signal from an external device that is attached to the
camera via the terminal block. In this submenu you can configure the
Night Input value (High or Low – referring to whether a higher-voltage
signal or lower-voltage signal will trigger Night Mode, depending on the
signal-sending device’s setup) and the Burst value (On or Off).
AUTO
and
EXTERNAL
mode settings
The camera will switch to DAY (Color) mode or NIGHT (B&W) mode
according to the selected values.
• LIVE LEVEL: This indicates the current light level.
• DAY
NIGHT: When the camera detects the current light level is lower than
this value, it’ll switch from DAY mode to NIGHT mode. Selectable values are
0~63.
• NIGHT
DAY: When the camera detects the current light level is higher than
this value, it’ll switch from NIGHT mode to DAY mode. Selectable values are
0~63.
Note:
1.
The difference in the selected values of DAY
NIGHT and NIGHT
DAY
should be more than 5, or else the camera might keep switching from
DAY
NIGHT and NIGHT
DAY constantly.
2.
It is not recommended to use an infrared illuminator when the camera is
in DAY/NIGHT > AUTO mode.
• DELAY TIME: The Delay Time will keep the camera from unnecessarily
switching between Day and Night modes when there is a sudden and short
change in the light levels. The camera will switch from one mode to the
other only if a switch-inducing change in light levels stays the same for the
selected number of seconds. The selectable values are 0 to 255 seconds.
Submenu of the
DAY / NIGHT > AUTO
and
EXTERNAL
modes
** DAY/NIGHT AUTO **
LIVE LEVEL
|||||||||||||||
|
||||| 063
DAY->NIGHT
||
|
|||||||||||||||||| 003
NIGHT->DAY
|||||||
|
||||||||||||| 025
DELAY TIME
|
|
||||||||||||||||||| 005
BURST
OFF
RETURN
<┘
