eIVP-CFS-IV-V0004
7
1.5
Rear Panel
1
2
3
4
5
6
No. Name
Description
1
PoE Ports
The LED indicator lightens in solid green when the cable is properly
connected to a 100 Mbps Ethernet network; The LED indicator lightens
in solid orange when the cable is properly connected to a 1000 Mbps
Ethernet network; The left LED will keep twinkling/off when Ethernet
data packets are being transmitted/received.
For more details, please
refer to
1.5.1 PoE Ports.
2
Serial Port
Serial port 1 to 4 (COM 1 to 4) can be configured for RS-232, RS-422, or
RS-485 with auto flow control communication. The default definition of
COM 1 and COM 2 is RS-232. If you want to change to RS-422 or RS-485,
you can find the setting in BIOS.
For more details, please refer to
1.5.2
Serial Port.
3
USB Port
There are 2 USB 3.1 connections available supporting up to 5Gb per
second data rate. It is also compliant with the requirements of Super
Speed (SS), high speed (HS), full speed (FS) and low speed (LS).
4
Isolated
DIO
There is a 16-bit (8-bit DI, 8-bit DO) connectors in the rear side. DI/DIO
support NPN (sink) and PNP (Source) mode. Each DI pin is equipped with
a photocoupler for isolated protection. For more details, please refer to
1.5.3 Isolated DIO
.
5
Remote
Power
On/Off
Switch &
LED
Terminal
Block
It is a 2-pin power-on or power-off switch through Phoenix Contact
terminal block. You could turn on or off the system power by using this
contact. This terminal block supports dual function of soft power-
on/power-off (instant off or delay 4 second), and suspend mode.
Pin 1: Ignition Pin2 :
SW+
Pin3 :
SW-
6
Power
Terminal
Block
eIVP-CFS-IV-V0004 supports 6V to 36V DC power input by terminal block
in the rear side. In normal power operation, power LED lightens in solid
green. eIVP-CFS-IV-V0004 supports up to 80V surge protection.
Pin 1: V+ Pin2 : V- Pin3 : Chassis Ground
