Value IP 288 / 368 / 468 Series
17
EMN468/468W
1.
Before screwing the camera onto the surface, stick the
Sticker
onto the surface to mark the position
for installation. According to the supplied
Sticker
, drill three holes on the surface, and optionally
drill a through-out hole for wiring the camera cables. Push the supplied three
Screw Anchors
into
the three holes on the surface.
2.
Unscrew the camera cover and screw the camera base to the surface by using the supplied
Screws
.
Note that for EMN468W, place the supplied
Gasket
between the camera base and the surface; and
then screw the camera base to the surface with the Gasket in the middle.
3.
Connect the LAN / PoE cable to the camera.
a.
Remove the
Screw Cap
from the
Cable Gland
.
b.
Insert a RJ-45 network cable (without the RJ-45 connector on the one end) through the
Cable
Gland
and
Screw Cap
.
c.
Place the
Waterproof Ring
into the LAN / PoE cable. Connect the RJ-45 cable to the RJ-45
Connector Cable. Tightly screw the
Cable Gland
and
Screw Cap
to the RJ-45 Connector Cable.
