7
Everest Lite Owner's Manual
GF0600055RevA06, October 006
Install batteries
Tools needed: Phillips screwdriver
1. Place batteries inside battery pack.
2. Connect red cable to positive (+) battery terminal and
black cable to negative (-) battery terminal
on the other
battery
, as shown at right.
3. Connect battery cable to both batteries at free positive
and negative terminal as specified in step 2.
4. Ensure that all wires are connected as specified in previ-
ous steps. Ensure that all connections are secure.
5. To retard corrosion, coat battery posts and terminals
with petroleum jelly after all connections are made.
6. Use a Phillips screwdriver to close the battery pack as
shown at right; turn it right side up (with handle/strap
on top).
7. Replace the battery pack in the wheelchair as shown at
right.
s
Caution: When installing the battery pack, press the
strap all the way down.
8. Pull the seat rotate lever while placing the seat on the
base frame, as shown at right. Ensure that seat is secure-
ly installed before continuing.
9. Connect the hand control connector to the cowl connec-
tor, as shown at right.
10. Do not attempt to operate wheelchair until batteries are
fully charged and installed as instructed here.
WARNING: Ensure that batteries and seat are installed
as described before operating wheelchair.
WARNING: Ensure that all cables are away from the moving parts of the wheelchair.