1
GF0600055RevA06, October 006
Everest Lite Owner's Manual
Adjust hand control extension—change sides
Tools needed: M5 hex key, cable ties
The hand control can be placed on either the right or left arm:
1. Remove cable ties that secure hand control
cable to extension, if any.
2. Disconnect the hand control connector
from the cowl connector.
3. Loosen hand control extension adjustment
knob.
4. Slide extension out from extension mount
bracket and remove it from arm.
5. Use M5 hex key to remove screws that se-
cure extension mount bracket to underside
of arm.
6. Remove plugs on underside of other arm.
7. Install extension mount bracket on under-
side of other arm—turn bracket around
so that knob faces outward (see picture at
lower right).
8. Install screws that secure extension mount
bracket to underside of arm. Use M5 hex
key to tighten.
9. Slide extension into bracket; tighten knob
when hand control is in desired position.
10. If desired, install cable tie to secure hand
control cable to extension.
11. Install plugs in other arm.
12. Connect the hand control connector to the
cowl connector.
WARNING: Ensure that hand control ex-
tension is locked in place, and
that all cables are away from
the moving parts of the wheel-
chair, before occupying or
operating wheelchair.
adjust hand control extension—
change sides
adjustment knob
cable tie
extension mount bracket
hand control
extension
arm
adjust hand control extension—
change sides, turn bracket around
adjustment knob
extension
extension
mount bracket
arm
screw