12022-12023-INS-LAB-RevD18 7
Install seat hooks
1. Place the seat, cushioned side down, on a flat
surface.
2. Assemble a seat hook to each corner of the seat as
shown at right in “install seat hooks”.
The L-hook
must be located as shown at right.
3. Tighten the screws securely to prevent the hooks
from sliding or turning.
Install padded seat
1. Ensure the seat stops are positioned on both seat
rails as shown at right in “seat stops” to prevent
the seat from sliding forward. Each screw and nut
should be tight enough to prevent the seat stop from
moving without deforming the end of the seat rail,
which would prevent easy folding of the Shower
Commode Chair.
2. Open the chair to its full width as shown at right in
“install seat”.
3. Place the seat on the seat rails as shown at right in
“install seat”
with the curved seat edge toward rear.
4. Hook the side with two J-hooks on the seat rails
with the front hook located
behind
the seat stop.
Lower the other side of the seat until it rests on the
seat rails.
5. Lift the seat rails about an inch to allow the
remaining hooks to engage the seat rails, then
push down on the seat to open the chair to its full
width and lock the seat in place.
Ensure the front
hooks are butted against backs of seat stops to
prevent the seat from sliding forward
Install commode pail
Slide commode pail into bracket below seat.
Install footrests
Set each footrest on Rehab Shower Commode frame
so that footrest hinge plates engage Rehab Shower
Commode hinge pins. Swing footrest inward and, using some force, firmly lock footrest in place
and ensure swingaway release lever is locked in forward position.
WARNING: Ensure back, padded seat, footrests, and arms are installed as described and locked
in place before occupying or operating Rehab Shower Commode, or personal injury and damage
to the Rehab Shower Commode could result.
seat,
cushioned
side down
L-hook
curved seat edge
seat rail
seat stop
J-hook
L-hook
seat stop
curved
seat edge
arm
front post
install seat hooks
seat stops
install seat
seat installed
J-hook
