Document No. 1112M001 Revision 1.8 Date: June 2013
12
4.0 Turbine Assembly and Installation
You will need the following hand tools.
►
Trestle, table or other support to support the turbine that is safe for
250kg (550lbs).
►
Plastic or rubber mallet, brass mallet/ hammer & 8mm pin punch.
►
Full set of ring spanners from 10mm – 24mm.
►
Metric socket wrench set.
►
Set of standard screwdrivers (plain and Philips).
►
Torque wrench suitable for torques of 0 – 180Nm (132ft lb).
►
Electrical pliers, cutters & crimping tool.
Refer to the diagrams and follow the instructions to assemble the
complete wind turbine.
This manual assumes that the support tower is already installed and
lowered to ground level ready for turbine installation.
4.1 Identification Marking
The turbine is fitted with a rating
label similar to the image.
Note down your turbine serial
number for future reference!
Note: Only the e400nb 3.5kW 250V version has MCS or SWCC Labels
