STYLE, GRILLED TO PERFECTION
2. PLACE THE HOOD ASSEMBLY (PART 28) ON TOP OF THE BARBECUE SO THAT THE TABS IN THE REAR HOOD
SIDES LINE UP WITH THE HOLES ALONG THE INNER EDGES OF THE BARBECUE. TAKE CARE NOT TO DAMAGE
3. PLACE 1 x M5 SCREW THROUGH THE HOLE OF A REAR HOOD SIDE TAB, FIX A FIBRE WASHER, AND LOOSELY FIT
ATTACHING THE HOOD TO THE BARBECUE
1. THE HOOD CARTON CONTAINS IT'S OWN HARDWARE PACK, CONSISTING OF FOUR M5 NUTS (PART 30),
FOUR M5 x 20 SCREWS (PART 29) AND FOUR FIBRE WASHERS (PART 31).
DAINTREE ESEE & KIMBERLEY ESEE HOOD ASSEMBLY
M
EITHER COMPONENT.
A M5 NUT. REPEAT FOR ALL FOUR HOLES, THEN FULLY TIGHTEN ALL THE NUTS.
4. CHECK THAT THE HOOD OPENS AND CLOSES CORRECTLY BEFORE USE.
28
29
29
30
31
5. THE HOOD CABLE FOR THE ESEE LIGHTING SYSTEM SHOULD RUN DOWN THE INSIDE OF THE RIGHT HAND
SIDE OF THE HOOD AND OUT THE HOLE IN THE BOTTOM CORNER. CONNECT ONE END OF THE HOOD
CABLE TO ONE END OF THE SWITCH CABLE.
6. TAKE THE NOW JOINED CABLES AND THREAD THEM THROUGH THE OBLONG HOLE IN THE REAR RIGHT HAND
CORNER OF THE CHASSIS "LEG". CONNECT THE REMAINING TWO LOOSE ENDS TO THE POWER ADAPTOR
CABLE (WITHIN THE TROLLEY). PASS THE POWER PLUG AND CABLE OUT OF THE REAR OF THE TROLLEY (DON'T
PLUG THE ELECTRICAL SYSTEM INTO A POWER SUPPLY UNTIL THE BARBECUE IS FULLY ASSEMBLED).
26
Summary of Contents for DAINTREE ESEE
Page 24: ...STYLE GRILLED TO PERFECTION 24...
Page 27: ...STYLE GRILLED TO PERFECTION 27...
