Eventide H90 Harmonizer, User Manual

Page: 53 / 176


Remember!
Begin at the beginning and go on till you come to the end: then stop.
Turn Quick Knob 1 to choose another parameter to map.
To un-map a parameter, set the Control Source to “Off”.
Press the Perform Knob to exit the mapping menu.

Tip
If you’d like to map many Program-level or Preset parameters at once, press the P/A/B LED to
quickly jump to other Preset or Program mapping options without ever leaving the mapping menu.
6.4.2. HotKnob
The HotKnob can be used to map multiple parameters to a single controller, much like the ribbon
controller from the H9. The H90 expands upon this control by giving you three HotKnobs; P, A, and B.
Press the Parameters Button to cycle through the different parameter view pages, and this will
determine which HotKnob is being used. Note that in Perform Mode, HotKnob P will always be used.
To map a parameter to a HotKnob:
Follow the above instructions to map a parameter and select a HotKnob as the control source.
If you selected HotKnob P, press the P LED to view the Program parameters page, and turn the
Perform Knob to control HotKnob P.
If you selected HotKnob A or B, press the A or B LED to view that Preset’s parameters page, and
turn the Perform Knob to control HotKnob A or B.
•
•
•
•
•
•
6. EDIT MODES
53