www.event-lighting.com.au
2
Safety Instructions
Warning
•
Do not open this device, there are no user-serviceable parts inside. Risk of electric shock.
•
Do not look at the light source when the device is on.
Caution: This unit's housing may be hot during and after operation.
•
Install this device in a location with adequate ventilation, at least 20 inches (50 cm) from adjacent
surfaces.
•
Do not leave any flammable material within 50 cm of this unit while operating or connected to
power.
•
Use a safety chain when mounting this device overhead.
•
Do not operate this device outdoors or in any location where dust, excessive heat, water, or
humidity may affect it.
•
Do not operate this device if the housing, lenses, or cables appear damaged.
•
Do not connect this device to a dimmer or rheostat.
•
ONLY connect this device to a grounded and protected circuit.
•
ONLY use the hanging bracket to carry this device.
•
In case of a serious operating problem, stop using immediately.
•
The maximum ambient temperature is 104° F (40° C). Do not operate this device at higher
temperatures.
Power Input & Power Linking
This device has an auto-switching power supply work with input voltage range of 100~240 VAC, 50/60 Hz.
Link up to the maximum 8A. DO NOT exceed this.
Fuse Replacement
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing
(anticlockwise).
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing and fix it.
