3.4.2
Wall Mounting Hole Location
Mounting holes are provided for Wall Mount purposes. The location of these holes are at the
back side of the cabinet and will accommodate ¼’mounting hardware. Four holes are provided
and all 4 should be used when wall mounting.
remove 3 screws and 2 nuts an washers
holding the gear tray
pull the Gear Tray forward
and lift up while supporting
from below
disconnect AC Input/Output connectors
and Installation Switch cable
remove 4 screws - remove the
AC Breaker/Terminal Block Assembly
Gear Tray
AC Breaker/Terminal Block
Assembly
Note:
Using the mounting holes
provided in the rear of the
enclosure requires removal
of the gear tray and AC
Breaker/Terminal Block
Assembly for access.
Note: See optional Wall Mounting Kit (next page)
Gear Tray and AC Breaker/Terminal Block Assembly Removal
Wall Mounting Dimensions
Pg. 6
