At this point you may want to insert the stopper in the sink and fill with water to check the sink flange seal and insure there are no
leaks
.
Hand-tighten sink flange
H
.
Place the mount ring over the sink flange and hold in place while installing the cushion mount
(
large side
down
).
Make sure the groove on the inside of the cushion mount fits over the lip on the sink flange, similar to putting
the on a plastic container Run your fingers around the entire cushion mount with slight pressure
.
Do not press too
hard
.
When the cushion mount is properly seated, the mount ring can be pulled downward over the cushion mount
and will be free to turn
.
Cushion Mount Detail
Bottom Bead
Groove
Top
Summary of Contents for FWD560+
