IMPORTANT:
Pay close attention to the order of the sink flange parts, as they have been correctly assembled by the
factory
.
A
.
Disassemble the sink flange assembly from the disposer by turning the mount ring to the left
(
clockwise
)
and removing it
.
B
.
Raise the mount ring toward the top of the sink flange
.
Remove the cushion mount and the mount ring
.
You may
want to practice installing the cushion mount at this point before you are under the sink
.
C
.
Unscrew the support ring from the sink flange and remove the fiber gasket
.
You are now left with the sink
flange and the rubber gasket
.
D
.
The rubber gasket is used instead of plumbers putty with stainless steel sinks
.
Some cast sinks will
require putty
.
E. If no putty is used, insert the sink flange through the rubber gasket into the sink opening
.
Do not turn the
flange once it is seated
.
F
.
If you use putty instead of the gasket, forma ring around the underside of the sink flange
.
Insert the flange
into the sink opening, press down hard to squeeze out excess putty
.
From under the sink, trim off excess putty
flush with the bottom edge of the sink opening
.
G
.
From underneath the sink, slip the fiber gasket onto the exposed sink flange
.
With arrows pointing up, screw
the support ring onto the sink flange and hand tighten until the sink flange will not move
.
COMPONENT
Summary of Contents for FWD560+
