EVBox Troniq 100, Installation And User Manual

Page: 24 / 84

• 60 Hz
This connection must be protected upstream by:
• A main switch or a disconnecting circuit breaker capable of at least 175 A to electrically isolate the
charger in case of maintenance.
• A transient voltage surge suppression in accordance with the local regulations.
CAUTION:
• To reduce the risk of fire, connect only to a circuit provided with 175 amperes maximum
branch circuit overcurrent protection in accordance with the National Electrical Code, ANSI/
NFPA 70.
Ground impedance must be lower than 20 ohms in dry conditions.
7.10.2. Phase rotation
In case of several Troniq 100 in the site location, to avoid overloading the first phase, it is
recommended to rotate the phase as below.
7.10.3. Grounding instructions
This unit is to be connected to a grounded, metal, permanent wiring system; or an equipment-
grounding conductor is to be run with circuit conductors and connected to equipment-grounding
terminal or lead on battery charger. Connections to battery shall comply with all local codes and
ordinances.
To achieve EMC compliance, the chassis must be bonded to earth locally to the charger.
EN
7. Prepare for installation
20