First remove the original equipment from le
ft
side of the handlebar. Grip, the brake lever and shi
ft
er. In reverse
order mount LCD display, LCD controller, accelerator, brake lever and grip. LCD controller and accelerator can be
op
ti
onally installed on the right side of the handlebar.
A
ft
er installing all controls, connect their connectors to the main harness.
Fasten Speed Sensor to the frame of the rear fork in an appropriate place so that between the sensor and the
magnet is not a distance greater than 5 mm. Now install the magnet on the spoke and set it, his magne
ti
c side,
to the sensor. Check, that the distance is 5 mm. If the sensor and magnet are installed correctly, when rota
ti
ng the
LED on the sensor is ac
ti
vated and
fl
ashes when passing through the magnet.
2 INSTALLATION OF CONTROLS AND SPEED SENSOR
www.EVBIKE.cz
LCD display
LCD controller
brake lever
grip
handlebar
accelerator
LCD display holder
right side
Connect controlers to the main harness
and then connect the connector from motor
unit.
brake lever
