9
0800 422 274
NZ
Getting Started (Cont.)
C
B
A
Assembly
The heater comes with the base packaged separately in the carton. Before you
can use the heater in an upright position, you have to attach the base.
• Place the heater flat on a table or benchtop so you can attach the base to
the underside of the heater. Take care when unpacking the heavy base, it
also contains the decorative washer.
• Remove the large plastic nut (not pictured) from the bottom end of the stand
pole (A).
• Put the decorative washer (B) and the weighted base (C) in place at the
bottom end of the stand pole and secure underneath the base with the
plastic nut.
• Your heater is now fully assembled. Place the heater in an upright position.
WARNING!
• Do not operate the heater without the base attached.
• Only operate the heater in an upright position (base on the bottom,
controls at the top), any other position could create a hazard.
