10
0800 422 274
NZ
IMPORTANT!
• Do not connect the appliance to the mains source until it is securely
assembled on the base.
• When turning the heater on for the first time it is normal for the heater to
emit a ‘new heater’ smell, which will quickly pass. This is no cause for
concern. Ensure good ventilation.
Using the Heater
• Your new Ceramic Tower Heater can be operated using the control panel at
the front of the unit, or via the supplied remote control.
• Place the heater in an upright position on a stable, level, dry and heat-
resistant surface, taking into considering all relevant safety information on
the previous pages.
• The appliance is for floor-standing use only. Ensure that there is sufficient
distance from the wall, fixtures and other appliances. The distance must be
at least 50cm to exclude the risk of fire.
Connection
• Before connecting the heater to your power source, make sure that the
Power Switch at the back of the appliance is set to the OFF [ O ] position.
• Insert the plug of the power supply cord firmly into an electrical wall outlet
and switch on power to the outlet. Always use a separate socket that has
no other high wattage appliances connected at the same time – do not plug
it into a power board or socket adaptor; do not use an extension cord. Also
ensure that the socket is easily accessible so that the cord can readily be
disconnected in an emergency.
Standby Mode
• Press the Power Switch at the back of the appliance to set the heater into
standby mode. Once electricity is supplied, the unit will emit a short beep
and the Power Indicator Light will illuminate.
• Under standby mode, only the ON/OFF [ ] button will be effective, pressing
any other button will be ineffective.
Operating Instructions
