EVA Stampaggi ANGLE, Instruction Manual, Page: 73 / 306

ALAR COOL FIRE
AL1 BLAC-OUT
DURING THE WORKING STAGE THE
ELECTRICAL ENERGY IS OUT
IF FOR MORE THAN 20 SECOND THE STOVE GOES OFF OR INTO BRAZIER
CLEANING'S PHASE; IF FOR LESS THAN 20 SECONDS IT GOES BACK TO THE
WORKING PHASE
POOR FLAME
ANTI-EXPLOSION DEVICE PLUG MISSING OR NOT CORRECTLY POSITIONED.
PARTIALLY CLOGGED VENT PIPE
CLEAN VENT PIPE IMMEDIATELY.
COMBUSTION AIR NOT SUFFICIENT BLOCKED ASPIRATION TUBE.
CLOGGED STOVE CLEAN BURN POT AND ASH DRAWER.
FAULTY / DIRTY EXHAUST BLOWER GET IT CLEANED BY A SPECIALISED TECHNICIAN CALL TECHNICAL ASSISTANCE
INADEQUATE COMBUSTION AIR SET
VALUE
CALL TECHNICAL ASSISTANCE.
ALAR FAN FAIL
ALARM ACTIVE FAN FAILURE
AL4 FAN FAILURE
Al. blower
FAULTY OR DEFECTIVE SMOKES FAN CALL TECHNICAL ASSISTANCE.
FAULTY CONTROL BOARD CALL TECHNICAL ASSISTANCE.
ECO / MODULA
SET ROOM TEMPERATURE REACHED / STOVE WORKS PROPERLY, THE STOVE WORKS AT POWER 1. INCREASE THE
AMBIENT TEMPERATURE SET TO GET THE STOVE BACK TO THE “WORKING” MODE.
STOP FIRE
CLEANING FIRE-POT
CLEAN BRAZIER
PERIODIC CYCLE OF BURN POT
CLEANING
STOVE WORKS PROPERLY
STAND-BY / ECO STOP / PAUSA SET ROOM TEMPERATURE REACHED / STOVE WORKS PROPERLY
ALAR DEP FAIL
ALARM ACTIVE FAILURE DEPRES
AL8 AFAILURE DEPRESS
Al. Vacuos-Al depr.
EXCESSIVE OR INADEQUATE VENT PIPE
LENGTH
FLUE DUCT NOT UNDER THE LAW: MAX. 6 METERS WITH A DIAMETER OF 80
mm; EVERY 90° CURVE OR (T) CONNECTION IS CONSIDERED AS 1 METER OF
PIPE.
CLOGGED OUTLET CLEAN VENT PIPE / CALL AUTHORISED TECHNICIAN.
BAD WEATHER CONDITIONS STRONG WIND.
ALARM ACTIVE ALARM FLOW
Al flux
DIRTY SENSOR, BLOCKED CHIMNEY OR
OPENED DOOR.
CALL TECHNICAL ASSISTANCE.
1ALAR SIC FAIL
ALARM ACTIVE SAFETY THERMAL
AL7 SAFETY THERMAL
Al. safety
LET STOVE COOL DOWN, MANUALLY
RESET THERMOSTAT ON BACK.
LET STOVE COOL DOWN, MANUALLY RESET THERMOSTAT ON BACK. IF THE
PROBLEM REMAINS UNSOLVED, CONTACT A SPECIALISED TECHNICIAN.
TEMPORARY POWER OUTAGE
LET STOVE COOL DOWN, MANUALLY RESET THERMOSTAT ON BACK. SWITCH
STOVE ON AGAIN.
FAULTY EXCHANGER BLOWER CALL TECHNICAL ASSISTANCE.
FAULTY THERMOSTAT WITH RESET CALL TECHNICAL ASSISTANCE.
FAULTY CONTROL BOARD CALL TECHNICAL ASSISTANCE.
ALAR SOND FUMI
ALARM ACTIVE PROBE EXHAUST
AL2 PROBE EXHAUST
Al. smokeP
FAULTY FUME SENSOR CALL TECHNICAL ASSISTANCE.
FUME SENSOR DISCONNTED CALL TECHNICAL ASSISTANCE.
ALAR HOT TEMP
ALARM ACTIVE HOT EXHAUST
AL3 HOT EXHAUST
Al smokeT
FAULTY FUME SENSOR CALL TECHNICAL ASSISTANCE.
FAULTY CONTROL BOARD CALL TECHNICAL ASSISTANCE.
FAULTY EXCHANGER BLOWER CALL TECHNICAL ASSISTANCE.
EXCESSIVE PELLET SET VALUE AT
MAXIMUM HEAT OUTPUT
CALL TECHNICAL ASSISTANCE.
T. elect (°C)
THE TEMPERATURE OF THE
MOTHERBOARD HAS EXCEEDED 70 ° C
LET THE STOVE COOL, AND THEN TURN IT ON AGAIN. IF YOU SEE THE ALARM
AGAIN, PLEASE CONTACT THE TECHNICAL ASSISTANCE.
REMOTE CONTROL NOT
CONNECTING (CERCA CAMPO)
POSSIBLE INTERFERENCE
TRY DISCONNECTING FROM THE MAINS SUPPLY ANY HOUSEHOLD APPLIANCE
OR ANY OTHER APPLIANCE THAT MAY GENERATE ELECTROMAGNETIC FIELDS.
REMOTE CONTROL DOES NOT
SWITCH ON
DISPLAY SWITCHED OFF CHECK BATTERY / FAULTY REMOTE CONTROL.