WARNING AND SAFETY NOTES
Charging
During charge process, a specific quantity of electrical energy is fed into the
battery. The charge quantity is calculated by multiplying charge current by
charge time. The maximum permissible charge current varies depending on
the battery type or its performance, and can be found in the information by
the battery manufacturer. Only batteries that are expressly stated to be
capable of quickcharge are allowed to be charged at rates higher than the
standard charge current.
Connect the battery to the terminal of the charger: red is positive and black
is negative. Due to the difference between resistance of cable and
connector, the charger can not detect resistance of the battery pack, the
essential requirement for the charger to work properly is
that the charge lead should be of adequate conductor cross-section, and
high quality connectors which are normally goldplated should be fitted to
both ends.
Always refer to the manual by battery manufacturer about charging
methods, recommended charging current and charging time. Especially, the
lithium battery should be charged according the charging instruction
provided by the manufacturer Strictly.
Attention should be paid to the connection of lithium battery espe cially.
Do not attempt to disassemble the battery pack arbitrarily.
Please get highlighted that lithium battery packs can be wired in parallel
and in series.
In the parallel connection, the battery s capacity is calculated by multiplying
single battery capacity by the number of cells with total voltage stay the
same. The voltages imbalance may cause fire or explosion .Lithium battery
is recommended to charge in Series.
08
