Here are the detailed procedures to make the charger work. All the screens
and operations will take LiPo-CHARGE program for example
Connection
Ensure to connect the battery to balance port when charging LiPo,Lilon,
LiFe and LiHV battery under balance mode.
OPERATION PROGRAM
1
).
Connecting
to
Power
Source
2
)
Connecting
The
Battery
3
).
Balance
Socket
C1-XR comes with the built in switching power supply.You can connect the
AC power cord directly to the main AC socket (100-240V AC) or attaching
directly to 12V car batteries. It is critically important that you use a fully
charged 13.8V car battery.
Important!!! Before connecting a battery it is absolutely essential to check
one last time that you have set the parameters correctly.If the settings are
incorrect, the battery may be damaged, and could even burst into flames or
explode. To avoid short circuits between the banana plugs, always connect
the charge leads to the charger first, and only then to the battery. Reverse
the sequence when disconnecting the pack.
The balance wire attached to the battery must be connected to the charger
with the negative marking. Take care to maintain correct polarity!(See the
wiring diagram below.)
This diagram shows the correct way to connect your battery to the AC while
charging in the balance charge program mode only.
batterie
Balance - Board
WARNING
:
Failure to connect as shown in this diagram will damage this charger. To
avoid short circuit between the charge lead always connect the charge
cable to the charger first, then connect the battery. Reverse the sequence
when disconnecting.
13
