Eurotron BTU 3000+, Instruction Manual, Page: 38 / 71

Instruction Manual MM850402 ed. 08b
38
•
Press [
ESCAPE
] (F1) to abort the printing.
•
Press [
FEED
] for paper advance. You can stop the paper advance by pressing the [
ESCAPE
] (F2) key.
NOTE:
IF YOU RECALL THE LAST MEMORY USING THE
A
VERAGE
3
FEATURE
(U
NI
G
AS
3000+
ONLY
)
OR YOU PERFORM AN AUTO
STORE WITH AUTOMATIC PRINTING
,
THE TICKET WILL SHOW THE DATA RELATED TO THE THREE MEASUREMENTS AND THEIR AVERAGE
VALUES BOTH CALCULATED AND MEASURED
. T
HE PARAMETER WILL BE PRINTED SEQUENTIALLY AS REQUESTED BY THE NEW PLANT
LEAFLET
.
7.8.1 Changing paper and ribbon
Open the cover pressing as photo below.
Remove the exhausted paper roll. You can use standard paper roll but you have to check before for its dimensions (max.
57mm ±1mm large and 48mm ±1mm roll diameter).
If necessary substitute the ribbon cartridge (cod. EE490002).
Approach the end of the new paper roll (cod. EE340005) to the slot under the printer.
Switch the analyzer on.
Keeping the [
HELP
] key down; press the [
X
] key to bypass the autozero procedure.
Press [
PRINT
] then press the [
FEED
] key for paper feed. Press the [
ESCAPE
] key when the paper comes out freely.
Close the cover inserting the paper end in its slot.
7.9 Pressure decay procedure
(option)
This is an additional feature that allows you to verify the condition of part or the entire plant. The system works with the
pressure decay principle. Be sure to isolate and empty the plant section you want to verify at first !