Eurotherm 590L Series, Product Manual, Page: 85 / 170

3URJUDPPLQJ # <RXU # $SSOLFDWLRQ ##
90<
8<3 / # 6HULHV # '& # &RQYHUWHU
352* # 6723 # 7,0(
Time to reach zero speed from 100% set speed in program stop mode(A7 OFF)
Range:
0.1 to 600.0 SECS
Default: 0.1 SECS
Slot: 2132
LINK Value Range: 0.0 to 100.00%
352* # 6723 # /,0,7
Delay time limit to allow program stop action (regenerative breaking) to achieve zero speed
before controller quench and coast stop. The timer is triggered by Program Stop command (A7)
going low.
Range:
0.0 to 600.0 SECS
Default: 60.0 SECS
Slot: 2229
LINK Value Range: 0.0 to 100.00%
352* # 6723 # , # /,0
Main current limit level in program stop mode assuming current limit not overridden by I Profile
or Inverse Time limits.
Range:
0.00 to 200.00%
Default: 100.00%
Slot: 2129
LINK Value Range: 0.0 to 100.00%
6723 # =(52 # 63(('
Zero speed level in program stop and normal stop modes at which the contactor delay timer starts
timing-out. At the end of this delay the contactor is de-energised.
See also "Contactor Delay" above.
Range:
0.00 to 100.00%
Default: 2.00%
Slot: 2133
LINK Value Range: 0.0 to 100.00%
&DOLEUDWLRQ
$50$785( # 9 # &$/ 1
Trim adjustment of the motor armature volts to give exactly 100% at the required actual voltage
value (e.g. 460V etc.).
Note:- Primary voltage calibration is achieved by the selection of resistors R8 and R9 on the
calibration board.
Range:
0.9800 to 1.1000
Default: 1.0000
Slot: 2151
LINK Value Range: 89.00 to 100.00%
Note - Calibration 1.1 is equivalent to a LINK value of 100.00%. Other calibration values within
the range use appropriately scaled LINK values. LINK values outside the range are clamped.
,5 # &203(16$7,21
Compensation for motor IR drop to improve regulation when using armature voltage feedback as
the speed feedback.
Range:
0.00 to 100.00%
Default: 0.00%
Slot: 2126
LINK Value Range: 0.0 to 100.00%
(1&2'(5 # 530
Motor top speed setting when using encoder feedback.
Range:
0 to 6000 RPM
Default: 1000 RPM
Slot: 2150
LINK Value Range: 0.0 to 100.00%