4
Eurotek RBT 7000
Preface
The Vehicle Brake Tester for Axle Weight and Brake Force is a tester to inspect the vehicle axle
weight and vehicle brake performance. Firstly, the operator drives the vehicle onto the rollers. A
signal will be sent to the computer by a force sensor and will show the axle weight on a
monitor/display Board in units of kg. When this reading is complete, the rollers automatically start
to rotate; the rolling resistance force is obtained before the driver applies the brake. When driver
applies the brake, the resistive force from the vehicle’s wheels will pass to a gear unit via a Chain
connected to the rollers. This force will then pass to a Force Sensor. The force sensor will transfer
the brake force into an electronic signal and send to the computer. Once analyzed by the
computer, inspection results will be displayed on the monitor/Display Board
.
1. Safety Instructions
1.1 Safety Operation Handbook
1. Do not use the equipment if any components are damaged
2. All equipments should be operated by qualified personnel only.
3. Maintenance, adjustment and calibration should be operated by qualified personnel only.
4. Do not exceed the Max capacity of the equipment.
5. Keep the equipment clean.
6. Adjust the longitudinal axle line of the equipment platform so as to parallel to the vehicle
driving direction.
7. Vehicle must pass across the equipment slowly.
8. Do not stand on the test equipment, including rollers, 3rd axles and sideslip plates.
9. Shut down the power immediately in case of an emergency.
10. Do not park or maintain vehicles on the equipment platform.
11. During the inspection, do not stand in the designated test area .
1.2 Operation Guideline for Brake Tester
Test Procedures must be carried as specified in the relevant inspection