6
ELECTRICAL CONNECTION
Check to make sure the main power supply and the outlet are appropriate to support a 110/120 V, 15 amp
single-phase circuit. The power supply voltage is indicated on the filter door on the bottom right of the
washing machine.
Grounding Instructions
This appliance must be grounded. In the case of malfunction or breakdown, grounding will reduce the risk
of electric shock by providing a path of least resistance for electric current. This appliance is equipped with
a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING!
Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided with the appliance. If it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
If the power supply cord is damaged in any way please contact the dealer.
Position the appliance so that the plug can be accessed and disconnected easily in case of
emergencies.
WATER SUPPLY CONNECTION
Before making the water supply connection, allow a quantity of water to flow from
the top. The water should be clean and free from impurities, especially where the
system is new or has been left unused for a length of time.
There are two hoses provided with the machine. The hot water hose is indicated
with a red strip running the length of the hose.
Insert the filter/washer supplied (Fig. 5) before connecting the water inlet hose to
the valve. Check that the other end of the hose is tight (Fig. 5A). Turn the supply
valve on (Fig. 5B).
The drain outlet should be positioned at a height of between 23” (60 cm) and 35”
(90 cm) above the floor (Fig. 6).
NOTE: To prevent siphoning, do not seal the drain hose connection into the drain
outlet.
If the machine is not connected to a drain outlet, place the drain hose and bracket
supplied over the edge of a sink or wash basin and anchor it in place.
FIG. 5
FIG. 5A
Cold
Hot
close
open
FIG. 5B
FIG.6
23.5" (60 mm) minimum
35" (90 mm) maximum
