6.
of LNB Frequency
Press “INS” key for approx. 3 seconds and the LNB
installation menu shown as followings
INSTALLATION
LANGUAGE
ENGLISH
LNB
LNB2
2
DECODER
CANAL
TV/SAT
AUTO
DiSEqC
ON
If you want change the preset, please proceed as
followings
Use
keys to move the cursor
to the
item to be changed.
Use
key to select for proper the settings.
1.
Press
key. There are 10 language modes for select.
l
TURKYE
keys to enter the frequency. Example
enter
by keying in
“9”
Use
keys to fine tine the LNB frequency,
per step.
3 . D E C O D E R
Select the output suitable for your decoder, there are four
types of output MAC, PAL
Filtered, or CANAL (Clamped).
Normally, preset to CANAL for CANAL PLUS
Decoder, or PREMIERE Decoder.
4.
This is used to control your TV (if connected to the
receiver’s TV
If TV/SAT is set to AUTO, TV automatically changes to
satellite channel when receiver is switched ON.
TV returns to last TV channel when receiver is
switched to STANDBY.
If TV/SAT is set to TV, satellite channel will only
appear when TV is set to AV input manually.
Use
key to select DiSEqC ON/OFF.
Corresponding DiSEqC commands sent out at each key
pressing.
6.
Press
key to exit and store the new setting in the
memory.
If not to be stored, press “INS’ key to exit the menu.
.
If necessary, the pre-programmed channel can be re-
programmed as followings:
Press (SET) key and the following menu appears
CH 600
VIDEO FREQ.
BANDWIDTH
CONTRAST
LT. ADJUST
AUDIO MODE
AUDIO FREQ.
VIDEO/AUDIO
H
.
2
..
0
NARROW
L: 5.58
R: 5.76
Use
and
keys to up/down the cursor
to
the item to be programmed.
Use
keys to select.
Numbers can be entered with (0) (9) keys.
Finally the entries are stored with the key for the
relevant program number.
It is possible to achieve optimal entry and selection by
observing the picture as well as listening to the sound.
If you do not want to store the new programmings in the
memory, press (SET) key again to exit the SET mode.
Normally, the background of OSD will be TV picture.
If necessary, press
key to change from TV picture
to a blue background for steady OSD display.
After programming, press
key again to resume the
TV picture.
Use
to select
type polarizer and
Tone switching.
OSD
TONE
H
OFF.
v
O F F .
O N .
O N .
This is the transponder channel frequency.
Look up the transponder frequencies of your favorite
programs in most of the satellite publications.
You may directly enter the frequency by using (0) (9)
keys, or up/down the frequency by using
keys.
