4.2
Install two AAA batteries, in battery compartment of
the handset.
Note If handset work erratically, replaces batteries.
Dispose of used batteries at a hazardous waste depot.
4.3
Press either
l
key on the front panel, or
key
on the remote handset to turn on your receiver,
Program of CH. 1, or the last channel you viewed, must
now be shown on your TV.
.
5. Alternative Set-ups and advanced
5.1
If your TV set does not have a
socket, then you must
connect
TV set via the UHF modulator output.
Connect the UHF modulator output
to the
VHF/UHF input of your TV set by using a coaxial cable.
Should you wish to continue to use the existing aerial
antenna (or the cable drop), you can connect it to the ANT
input
of your receiver.
5.3
The built-in UHF modulator provides the satellite
programs in TV UHF
and was preset at CH.36
It is possible to adjust the CH ADJ screw
and
You can now look up the program table attached with
the user manual for your favorite channels. The table
lists 600 channels of satellite TV, or Radio programs
which have been preset and stored in your receiver.
Use channel
key to up/down select channels,
or use “0” “9” key to enter channel number.
The channel number will be shown both on LED
display and on TV screen.
,
key to adjust the sound volume.
Note If necessary, press to store the volume level
in the memory, then, the volume will be with the
channel all the time.
If not stored, volume will resume to
value, after changing channel.
Press
key to turn off the sound. Press
key again to resume the sound.
When your receiver is not in use, press either key,
or
key again to turn off your receiver to standby.
4.4
Press
key to be in favorite channel mode.
Use
keys to select the favorite channel.
Press
key again to exit the favorite mode.
4.5
Press ‘RADIO” key to be in Radio mode.
Use CH. “A”
keys to select radio channel.
Press ‘RADIO” key again to exit the Radio mode.
In Radio mode, the screen is blue and no picture.
Note The set-ups of Favorite channel and Radio channel
Please refer to
7 programming.
change the modulator channel from CH.30 to CH.45 if
interference from neighboring TV stations arises in
channel 36.
By switching on the TSG switch
A black and
white bar test pattern can be for easy channel
confirmation.
After the tuning has been completed, TSG ON/OFF
switch
must be switching OFF.
If you wish to listen the sound or RADIO from your
receiver over your stereo system, connect your stereo
system to the L/R audio outputs
of your receiver by
using
cables.
