EUROPRO Mini-Sandblaster 10L, User Manual, Page: 17 / 20

SANDBLASTER 0701AREN10MAS
17
11. TROUBLESHOOTING
ANOMALY POSSIBLE CAUSE CHECKING POINTS SOLUTION
I. Air does not come
out of the nozzle
A) The compressor is not
connected or turned off
Feed air compressor Connect the compressor to the
sandblaster and start it
B) Blocked nozzle Nozzle Disassemble the nozzle from the
gun and blow through it to remove
the obstruction
C) Sand flow rate regulator
too open
Product outlet regulator Close the regulator until you reach
the appropriate opening level. Blow
the hose and the nozzle
D) Excessive granulometry of
the used abrasive
Abrasive Empty the tank and fill it with the
suitable size abrasive. Blow the
hoses to remove residual abrasive
E) Blocked product hose Product hose Disassemble the product hose and
clean it
F) The three-way valve
located on the regulation
box does not work
Three-way valve Replace it
G) The gun valve does not
work
Gun valve Replace it
II. Abrasive does not
come out of the
gun (air only)
A) Tank without abrasive Tank Fill the tank with abrasive
B) Blocked abrasive product
outlet
Product outlet Move the product outlet regulation
control to increase the flow rate
Clean the outlet pipes of the tank
C) Excessive granulometry of
the used abrasive
Abrasive Empty the tank and fill it with the
suitable size abrasive. Blow the
hoses to remove residual abrasive
D) Closed abrasive outlet
regulator
Product outlet regulator Move the product outlet regulation
control to increase the flow rate
III. Non-uniform
abrasive product
flow
A) Wet or with strange
particles abrasive
Inside the tank Empty the tank and fill it with dry
and filtered abrasive
B) Excessive granulometry of
the used abrasive
Abrasive Empty the tank and fill it with the
suitable size abrasive. Blow the
hoses to remove residual abrasive
C) Sand flow rate regulator
too open
Product outlet regulator Move the product outlet regulation
control until you reach the desired
flow rate
IV. The result of the
application is not
satisfactory
A) Unsuitable nozzle for
application
Nozzle Replace the nozzle (according to
Table 1)
B) Lack of hose tightness Hoses Replace the hoses
C) Inappropriate working
pressure
Pressure regulator Move the air regulator until you
reach the desired result
D) Inappropriate abrasive for
the work to be done
Abrasive Ask the abrasive product supplier
information about the most
recommended product for each
work
V. Air outlet through
the safety valve
A) Excessive air pressure of
the compressor that feeds
the sandblaster
Compressor manometer Adjust the compressor air outlet
pressure to a maximum of 6 kg /
cm²
VI. Insufficient air
outlet through the
nozzle
A) Blocked purifying filter Purifying filter Clean the purifying filter
B) Blocked nozzle on the
hose part
Nozzle - Hose Disconnect the hose from the
sandblaster and blow from the
nozzle to unblock it