202204-585-ENG
User manual - Compact-Pro 30 BASIC
P11
4. USE OF THE MACHINE (continued)
4.2. STARTING UP
1.
Install the machine on a flat floor.
2.
Connect electrically (16 A minimum plug, extension cable 40m maximum in 3 x 2,5 mm² minimum).
3. Connect the hose (and its extension if necessary) on the outlet (C).
4.
Put water into the tank.
5.
Switch on the machine (button (K)).
6. Set the motor speed to 4 using the potentiometer (M).
7. Put the button (N) on MANU, the machine starts.
8.
Wait until the water comes out of the hose (or the tank is emptied).
9. Put the button (N) back to AUTO, the machine stops.
10.
Empty the water from the hose and drain the remaining water from the tank using the drain plug (H).
11.
Connect the lance in open position without the nozzle.
12.
Fill the tank with product. Put the button (N) on MANU, the machine starts.
13. Check that the hose does not clog (check the pressure on the manometer (C)) and that the product
descends correctly.
14. When the product comes out of the hose, put the button (N) back to AUTO to stop the machine and
THEN close the lance.
15. Install the desired nozzle at the end of the lance.
16. Verify that the air drains on the machine chassis (I) are properly closed.
17. Connect the air hose on the connector (D).
18.
Start the compressor (button (L)) then set the machine speed between 2 and 7 depending on the
desired flow rate.
19.
When the lance is opened, the machine will start.
In the case of a traditional product, prepare a mixture of water and liquid cement and pour
it into the machine tank. Start the machine with button (N) on MANU. Wait for the mixture
to come out or until the tank is empty. Put the button (N) back to AUTO.
