40
OPERATING the FIREPLACE
Element4 Gas Fireplaces
European
Home
.com
Note: The system shuts off the appliance completely if there is no change in the flame height
for 5 days.
Setting °C/24 Hour or °F/12 Hour Clock.
Press
OFF
and
È
to toggle between °F/12 hr and °C/24 hr clock.
Setting the time.
Simultaneously press the
È
and
Ç
buttons, the display now flashes.
Press
Ç
to set the hour and
È
to set the minute.
Press
OFF
to return to manual mode.
Igniting the Appliance.
On the remote control, simultaneously press and hold the
OFF
and
Ç
buttons.
An acoustic signal indicates that the start sequence has begun.
The electronic system then checks that the main gas is flowing and ignites the main burner;
this may take up to 20 seconds.
NOTE:
During start-up, the
MANUAL
knob on the gas valve cannot be in the
MAN
position. See
Figure 44.
Changing the Mode of Operation.
Briefly pressing the
SET
button changes the mode of operation in the following order:
Man
-
Temp
-
Temp
-
Timer
- back to
Man
Man - Manual Flame Height Adjustment.
UP
DOWN
BEFORE THE FIRST FIRE
1.
Make sure all construction materials have been removed from inside and around the fireplace.
2.
Confirm the proper placement of the burner media.
3.
Confirm that the controls are properly connected.
4.
Check the gas supply for leaks.
5.
Close and properly clamp the glass panels.
6.
Check that the venting is unobstructed and in proper working condition.
USING THE REMOTE CONTROL ELECTRONIC IGNITION SYSTEM
OFF
SET
PAIRING THE REMOTE AND RECEIVER
(Resetting the System)
The remote control must be paired to the receiver prior to first use. This is done as follows:
1. Press and hold the receiver reset button (Figure 42) until you hear the second of two beeps. After the second beep release the
reset button and,
2. within twenty seconds, press and hold the
È
button on the remote until you hear the second of two beeps. Release the
È
button.
Figure 42
. Receiver
RESET
BUTTON
Figure 43
. Remote Control
