SNOWING CHRISTMAS TREE
8
Make sure that the small hole in the cover is in the middle
and distribute the 8 folds evenly.
3. Place the components described under point 1 on the
prepared cover as shown in illustration 3. The outpouring
of the protection pole must lie over the opening in the
cover and the poles must lie on the cover folds.
4. Carefully push the pole connectors into the opening in the
cover and pull the cover to the top around the poles. The
poles are bended in the cover circle. Pull the cover close
on all sides to the ends of the poles. Make sure that the
poles are still on the cover folds.
Caution: by bending the poles, an enourmous power is
built up. Please be careful that you do not let loose the
poles. In order to avoid accidents, make sure that there
are no persons or fragile objects in the nearby area. Do
not bend the poles too much, otherwise they make
break.
The hazards as described above are also valid for
breaking down the construction.
5. Take the remaining 8 support cover poles (5-6) and
enlarge the poles via the connectors.
6. Carefully tighten the cover on all sides to the ends of the
poles. Make sure that the poles are still on the cover folds.
4.2 Putting frame and base together
1. Connect the 8 circle base poles (5-2) via 8 T-connectors (5-
1). Make sure that the pole ends are completely inserted
into the connectors in order to have a stable construction.
Direct all T-connectors in the same direction.
2. Now bend the connected poles into a circle as shown.
Make sure there is no bystander or fragile object nearby,
so as not to cause injury or damage in the event any
connecting pole slips out of hand.
3.
In the same way connect a second circle with 8 circle base
poles (5-2) and 8 +-connectors (5-3) Connect both circles
with the support base poles (5-4). Make sure that the UP-
arrow on the +-connectors shows upwards!
