SNOWING CHRISTMAS TREE
9
4.
Take the base set, the support base poles and the included
screws and fix the parts with the screws on the base as
shown in the illustration below.
5.
Place the circle construction upside down in the cloth an
insert the upper end of the 8 +-connectors (UP-arrow
downwards) through the 8 little holes in the cloth base.
Finish by tightening the drawstring with a knot so as to give
the frame its round shape.
6.
Plug the power unit into the controller socket. Place the
base at the desired position on the floor. Make sure that
the controller and the power unit are outside the base in
order to operate them later.
7. Take both parts of the Christmas tree and insert the lower
part first into the socket holder. Connect the upper tree part
to the lower part. Caution! Tightly engage both parts. Any
leakage during operation may cause unwanted spraying of
the snowflakes. Unfold the branches until you have a
beautiful tree shape.
Tip:
In order to have the most
beautiful shape, we recommend to adjust the branches to
horizontal.
8.
Attach the end support (11-3) as shown above on the tree
and fix it with the enclosed screws. Caution: the screws
must be tightened firmly.
9. Decorate the branches with the ornaments. Make sure they
are properly fixed as falling parts could block the
circulation of the snowflakes. Attach the light chain around
the branches. Connect the connection cable to the
corresponding input jack in the base.
Tip:
We recommend
to bend the end of the branches with ornament a little
upwards.
