23
distribute warm air via the upper grille. Don’t forget! This function only works if the
atmospheric screen is working! Pressing this button again will switch the heating
off but the atmospheric lighting will continue to work.
Pressing the ‘2000W’ button sets the heating at full capacity (2000 Watt). The red
light next to the button will be illuminated and the ventilator will start to distribute
warm air via the upper grille. Don’t forget! This function only works if the
atmospheric screen is working! Pressing this button again will switch the heating
off but the atmospheric lighting will continue to work.
Every time you press a button you will hear a 'beep' and this indicates that the
fireplace has 'picked up' the command.
Operating using the remote control:
It takes a little time before the receiver responds to a signal
transmitted from the remote control. Do not press a button
more frequently than once per two seconds as this will disrupt
the function.
You switch the atmospheric lighting on and off using the
red ON/OFF button on the remote control.
The black buttons '1000W' and '2000W' have the same
function as the '1000W' and '2000W' buttons on the
fireplace (see above).
Pressing and holding the black 'dimmer' button increases
and decreases the brightness of the light. Release the
button when the lighting reaches the desired intensity.
Every time you press a button you will hear a 'beep' and
this indicates that the fireplace has 'picked up' the
command.
When you switch a particular function on using the remote
control, the red light next to the corresponding button on
the fireplace will be illuminated.
If you want to switch the device off for an extended period, set the central ON/OFF
switch to OFF again and remove the plug from the power socket.
Safety feature
The Harstad atmospheric fireplace is equipped with an
overheating safeguard.
In
case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar.
If this happens, turn the fireplace off by switching the main switch to O and remove
the plug from the socket. Leave the fireplace to cool down for at least 15 minutes and
remove the cause of overheating. You can then switch the fireplace back on.
If the device overheats again or you cannot ascertain the reason for this, take the
fireplace to your service point to be checked/repaired.
Cleaning and maintenance
Always remove the plug from the socket and let the fireplace cool down before
cleaning or touching.
