10
Position
Excess moisture will travel throughout your home, in the same way that cooking smells
waft to every room in the house. For this reason, the dehumidifier should be positioned,
so that it can draw this moist air towards it from all over the home.
Alternatively, if you have a serious problem in one area you can begin by positioning the
dehumidifier close to this area and later moving it to a more central point.
When positioning the dehumidifier, ensure that it is placed on a level surface and that
there is a minimum of 10 cm (4") of space on either side of the unit to allow for efficient
airflow.
If you move the unit, it should first be switched off and the water tank emptied.
We do not recommend the use of an extension lead, so please try to ensure that the unit
is sufficiently close to a fixed mains socket. If it is necessary to use am extension lead,
use one with earthing and please ensure the diameter of the wires of the cable is at least
1,5 mm2.
Don’t place the device near a heater, stove or other heat source, and not in full sunshine.
When the dehumidifier is in operation, outside doors and windows should be closed
when necessary for most efficient use. However, do not use the device in a sealed or
very small space.
Operation
1. Turn the
on / off button
,
also
humidistat
,
completely
to
OFF /
MIN
mode: the device
is
now
deactivated
.
Plug into
a
earthed
mains
socket
, corresponding to
the
specifications on
the rating label
.
2. Turn the
humidistat
clockwise
direction
MAX
.
At one point
you will hear
the
compressor
catch on and
the device
starts
its operation
.
The further you turn
the
knob
to
MAX
, the lower
you set the
humidity
.
3. When
the unit
reaches
the set
humidity
, it will
automatically stop
his works
; when
the
humidity
rises above the
set value,
the machine will turn on again.
4. When
you turn
the on / off
button completely to
MAX, the unit will operate
continuously
;
by turning
te button back to
OFF
/
MIN you switch off the device.
Press the ON / OFF button again to switch it off again.
5. After use, always remove the
plug from the socket
.
Drainage
While the water tank is full, the compressor will stop for
self-protection and the water full indicator will turn into
red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into
space. Make sure it is properly positioned, in order for
the 'water full' sign to go out and your dehumidifier is
operating.
Please note
: in case, the water tank has not been
positioned well, the water full indicator will turn into red.
The equipment does not work.
