29
29
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Do not use the fireplace before it has been completely installed according to the
instructions and you have read the instruction booklet fully!
This device was designed to be permanently hung on a wall. Ensure the wall is
sturdy, completely vertical, is not sensitive to vibration and is not flammable.
Make sure it is not made of synthetic material and or covered with flammable
material. Be aware of pipes that may be contained within the walls when drilling
holes.
Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a 30
mA earth leakage circuit breaker). This socket must be located to the right of the
fireplace.
There must be at least 30 cm distance between the base of the fireplace and the
ground, however, you are advised to place the fireplace at a height of 60 cm. for
the best sight. There must be at least 20 cm distance between the fireplace and
the side walls, at least 100 cm. between the fireplace and the ceiling. Do not
hang the device directly under or in front of an electrical socket (see diagram 1).
The wall supports must be attached horizontally (use a spirit level!) to the wall.
Determine the location of the wall supports (take the above into account), mark
the location of the screws and drill 4 holes at the marked places using a 6 mm
