13
English
Technical data
Type
C.U. 2000 Multi
Supply voltage
Volt/Hz
220-240 / 50
Maximum capacity
Watt
2000
Settings
0 – 1350 – 2000
Thermostat
+
Dimensions
cm
16 x 14 x 53
Weight
kg
3
General safety instructions
1.
Before using the machine, carefully read this entire instruction manual.
2.
Before using your new heater, check it, including cord and plug, for any visible damage.
Do not use a damaged heater, but send it back to your dealer for replacement.
3.
If you are using this appliance for the first time, it may emit unpleasant odours and make
crackling noises. Therefore, on initial use, set it to full power in a well-ventilated space.
4.
This heater is strictly intended for normal domestic use. Only use it as an additional
heater in your home.
5.
This heater in not suitable for use in wet or damp spaces such as bathrooms and laundry
rooms. Do not place the heater in the vicinity of taps, bathtub, shower, pool, fountains
or other sources of moisture. Make sure it cannot fall into water and prevent water from
getting into the heater itself. If, at any time, the heater does fall into water, unplug it
immediately! Do not use a heater that has a damp interior but have it repaired. Never
immerse the heater, cord or plug in water and never touch it with wet hands.
6.
The supply voltage and utility frequency, specified on the machine, need to match those
of the socket that is used. The electrical installation needs to be protected by a residual
current device (max. 30 mAmp).
7.
Fully extend the cord before plugging in the heater. Make sure it does not come into
contact with any part of the heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it with mats, carpet strips, or similar
and make sure it is not placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do not lead the cord around
sharp corners and do not roll it up too tightly after use!
8.
If possible, do not use an extension cord, as this poses the risk of overheating and fire.
If the use of an extension cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x 2.5 mm² and a minimum
permissible power of 2200 Watt/10Amp. To prevent overheating, always fully extend
the cord!
9.
To prevent the circuit being overloaded and fuses being blown, make sure no other
appliances are connected to the same socket or wired to the same electrical circuit as
the heater.
10.
Do not use the heater outdoors and do not use it in spaces, smaller than 15 m³.
11.
A heater contains hot and/or glowing and sparking components. Do not, therefore, use
it in areas where fuels, paint, flammable liquids and/or gasses etc. are stored.
12.
Do not place the heater near, under, or directly opposite a socket and do not place it
near an open fire or other heat source.
13.
Do not use the heater near or directly opposite furniture, animals, curtains, paper,
clothes, bedding or other inflammable objects. Keep them at least 1 metre away from
the heater!
14.
Do not ever cover a heater! The heater’s air inlets and outlets should never be
obstructed in any way, so as to prevent the possibility of fire. Never use the heater to
