Eurolux ED1 10P5 V, Installation Manual

Page: 130 / 164

130
EN
In this case:
1. First always disconnect the appliance from the power supply.
2. Take out baskets.
3. Remove the
fi
lters.
4. Scoop out water, use a sponge if required.
5.Check the area and remove any foreign objects.
6. Install
fi
lters.
7. Re-insert baskets.
8. TROUBLESHOOTING
AUTOMATIC FAULT WARNINGS AND WHAT TO DO
TROUBLE
CODE
POSSIBLE FAULT WHAT TO DO
FF
Water inlet system failure
Make sure the water inlet tap is open and water
is
fl owing.
Separate the inlet hose from the tap and clean
the
fi
lter of the hose.
Contact for service if the error continues.
F5
Pressure system failure Contact for service.
F3
Continuous water input Close the tap and contact for service.
F2
Inability to discharge water
Water discharge hose and
fi
lters may be
clogged.
Cancel the programme.
If the error continues, contact for service.
Contact for service.
F8
Faulty heater Contact for service.
F1 Over
fl ow
Unplug the machine and close the tap.
Contact for service.
FE
Faulty electronic card Contact for service.
F7. Overheating Contact for service.
F9 Divisor position error Contact for service.
F6
Faulty heater sensor Contact for service.
HI
Hihg voltage failure Contact for service.
LO
Low voltage failure Contact for service.