EuroLite VLS-1200RGB MICRO 30K, User Manual

Page: 39 / 48

www.eurolite.de
39
DMX operation DMX ADD 001 to DMX ADD 512 Select a value with UP/DOWN; confirm with
ENTER.
SLAVE When interconnecting several
lasers with DMX cables, the slave
units can be controlled with the
master unit. Press ENTER to activate master/slave mode.
SETTING COLOUR: SINGLE COLOUR,
DUAL COLOUR, MULTICOLOUR Select a show with UP/DOWN; confirm with
ENTER.
Setting Direction: MIRROR
SY : N, SX : N SY : N, SX : Y
SY : Y, SX : N SY : Y, SX : Y
Music sensitivity
Automatic Mode (Auto Show)
Press [FUNC] repeatedly until the display shows “MODE: AUTO SHOW 1”. The device operates in stand-
alone mode and displays a programmed show, which can be controlled by the built-in microphone, if desired.
Use the [UP] and [DOWN] buttons to select one of the programmed shows listed in the table below. Press
[ENTER] to save the value and to start operation in “Auto Show” mode.
Indication Show
AUTO SHOW 1 Automatic show 1
AUTO SHOW 2 Automatic show 2
MUSIC SHOW 1 Sound-controlled show 1
MUSIC SHOW 2 Sound-controlled show 2
The laser is switched off, if a sound-controlled show is selected, but the microphone does not receive any
sound.
Operating Mode SD Show
Press [FUNC] repeatedly until the display shows ‘MODE: SD SHOW dir’. If there's a SD memory card with
stored show programs in the card slot, you can select a directory on the memory card using the [UP] and
[DOWN] buttons. If the name of the desired directory appears in the display, press [ENTER] to confirm.
Now you can determine, whether the device should run a single ILDA show (based on a *.ild file) or a
programmed show (based on a *.prg file). Use the [UP] and [DOWN] buttons to toggle between ‘MODE: SD:
PRG SHOW’ and ‘MODE: SD: ILD SHOW’. Then press [ENTER] to confirm.
Now you can choose the file to be played from the current directory. Press [UP] or [DOWN] until the desired
name appears in the display, then press [ENTER] to confirm. The unit now starts running the show from the
selected file in an endless loop.
Notes:
Secure Digital Memory (SD) cards can be used to store and play programmed laser shows. The device
supports the following file types:
• *.ild: Binary file format for storing vector lists for laser shows. The format has been standardized by the
International Laser Display Association (ILDA). Files of this type can be created using specialized
computer software.
• *.prg: Text file format that is used to call up several *. Ild files in succession. Files of *. prg type can be
created or modified on your computer with a simple text editor such as ‘Notepad’.
The unit supports up to 100 folders with up to 255 files in each directory. The SD memory card must be
formatted as FAT32 file system. The maximum length of the file and directory names is eight characters.