www.eurolite.de
38
7
OPERATION
Starting the Device
Carry out the following steps to take the unit into operation:
1
Check to see whether all laser safety precautions have been taken. Make sure that nobody is in range
of the laser beam.
2
Insert the safety key into the lock.
3
If not already done, connect the device to a mains power outlet and the emergency switch.
4
Turn the unit on using the power switch. The power indicators lights up. The unit is now operational.
5
Turn the safety key to turn the laser beam on.
6
Now you can start the projection from your software or laser controller.
7
With the brightness controls R, G and B you can adjust the color balance for the red, green and blue
laser diode.
8
With the controls X SIZE and Y SIZE you can adjust the horizontal and vertical extend of the laser
show.
9
With the switches X INVERS and Y INVERS you can select mirroring on the X and Y axis.
10
In the event of a dangerous situation, immediately turn off the laser system with the power switch or the
remote emergency switch.
Stopping the device
Carry out the following steps to stop the unit:
1
Turn the safety key to turn the laser beam off and pull the key off. Keep the safety key in a safe place.
2
Turn the unit off using the power switch or the remote emergency switch
3
Additionally, you can disconnect the device from the power supply.
Main Menu
The built-in control panel of the unit features four operating buttons and a display which shows all operation
statuses. After switching on, information about the unit will shortly be displayed, and then the operating mode
selected last is activated.
1
Press [FUNC] to activate the main menu and select one of the operation modes.
2
When the display is flashing, use the [UP] and [DOWN] buttons to change the values.
3
When the display shows the desired value, press [ENTER].
4
To discard all changes and exit back to the main menu press [FUNC] or wait a minute.
All previous settings are saved even if you disconnect the device from the mains power supply.
FUNC
UP/DOWN
ENTER
Built-in
programs
AUTO SHOW1, AUTO SHOW2
MUSIC SHOW1, MUSIC SHOW2
Select a show with UP/DOWN; confirm with
ENTER.
SD card
operation
Select a folder on the SD card;
FILE: XXXXXXXX
Select a folder with UP/DOWN; confirm with
ENTER.
ILDA show or PRG show
ILDA show: indication of ILD files
PRG show: indication of PRG files
Summary of Contents for VLS-1200RGB MICRO 30K
Page 24: ...www eurolite de 24 Integrierte Muster ...
Page 43: ...www eurolite de 43 Built in Patterns ...
Page 46: ...www eurolite de 46 NOTES ...
Page 47: ...www eurolite de 47 ...
