20
•
EN
SETUP OF THE ACCESSORIES
Installation/Replacing the illuminant
WARNING!
Electric shock caused by high voltages
Within the device there are areas where high voltages may be present. Always disconnect the device
from the mains socket prior to installing or replacing a lamp.
WARNING!
Risk of burns at the surface and in case of inappropriate handling of the illuminant
The device and the illuminant become very hot during operation. Let the device cool down for at least 5
minutes before replacing the illuminant.
The device is supplied with illuminant. Do not install illuminants with a higher wattage! Illuminants with a higher
wattage generate temperatures the device was not designed for. Damages caused by non-observance are not
subject to warranty. Observe the safety instructions of the illuminant manufacturer.
1 Please remove the fixation ring by pressing it together.
2 If replacing a defective lamp, remove the lamp from the pinspot and loosen the wires.
3 Loosen the screws on the new lamp with an appropriate screwdriver.
4 Connect the wires with the new lamp.
5 Tighten the screws.
6 Insert the lamp in the housing.
7 Fixate the lamp with the fixation ring.
