EuroLite LED TMH-H90, User Manual

Page: 29 / 36

00131337, Version 1.0 29/36
Control Board
The Control Board offers several features: you can easily set the starting address or run the pre-
programmed program.
Press OK 2 x until the display is lit. Browse through the mode menu by pressing the arrow buttons (up and
down). Press OK 2 x in order to select the desired menu. Browse through the main menu by pressing the
arrow buttons up and down. Press OK to enter the respective menu item of the main menu. You can change
the selection by pressing the arrow buttons (left and right). Press OK in order to confirm. You can leave
every mode by pressing the arrow buttons (left and right). The functions provided are described in the
following sections.
Default settings shaded.
Mode menu Main menu Sub menu Function
Setting
RunMode
DMX/Sound/Random/
Auto 1, Auto 2, Auto 3,
Auto 4
DMX mode / music control / random auto
program / auto program 1 - 4
Address 001~ 512 DMX address setting
Channel 25 CH Number of DMX channels
Sens 1 – 99, 80 Mic sensitivity
Invert - X ON/OFF
Reverse movement
Invert - Y ON/OFF
Swap - XY ON/OFF
PAN-TILT swap
Encoder - XY ON/OFF Automatic PAN/TILT adjustment
NoDMX Keep/clear Action if no DMX
DisplaySave ON/OFF Display turn off
LinearColor ON/OFF Switch color change from step to linear color
LoadDefault OK/Cancel Restore factory settings
Test PAN ... PAN = XXX ... Test function
Offset
Service function only
Password 123456
Advance
InvertDisplay Display reverse 180 degrees
TimeReset Clear fixture running time
TopTem 0 – 120, 80 Lamp off at temperature
HardWare
Pan Hall Y
Service function only
SysInfo
Ver Software version
TotalHours Fixture running time
PartialHours Running time since last switch-on
Temperature Inside temperature
Setting
Run Mode
DMX mode
This mode allows the unit to be controlled via any standard DMX controller.
Sound
With this function, you can run the internal program sound-controlled.
Random auto mode
With this function, you can run the random internal program.
Auto mode (Auto 1 - 4)
With this function, you can run 4 different internal programs.
Address
With this function, you can set the desired DMX address via the Control Board.