00081193, Version 1.0
27/39
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution:
Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
DANGER OF FIRE!
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
CAUTION!
Use an appropriate clamp to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
The Moving-Head can be placed directly on the stage floor or rigged in
any orientation on a truss without altering its operation characteristics
(see the drawing).
The fixture’s base enables to be mounted in two ways.
Make sure that the Omega-holder is always in line with the truss
structure when installing the device vertically.
For overhead use (mounting height >100 cm), always install an
appropriate safety bond.
You must only use safety bonds and quick links complying with DIN
56927, shackles complying with DIN EN 1677-1 and BGV C1 carbines.
The safety bonds, quick links, shackles and the carbines must be
sufficiently dimensioned and used correctly in accordance with the
latest industrial safety regulations (e. g. BGV C1, BGI 810-3).
Please note:
for overhead rigging in public or industrial areas, a series of safety
instructions have to be followed that this manual can only give in part. The operator must
therefore inform himself on the current safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or
insufficient safety precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe
fixation spot. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be
used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw a clamp via a M10 screw and nut onto the Omega-holder.
Insert the screws of the Omega-holder into the respective holes on the bottom of the device. Tighten the
screws fully.
