www.eurolite.de
32
6
MAKING THE CONNECTIONS
Connection to the Mains
The light set uses an auto-range power supply that accepts input voltages between 100 und 240 volts and
allows for powering further devices.
1
Connect the device to the mains with the power plug. Thus the unit is switched on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the light set to the mains voltage via a dimmer. For a more convenient operation,
connect the light set to a mains outlet which is switchable.
Power Supply of Further Devices
The jack POWER OUT allows for power supply of further devices, e.g. further light sets. To interconnect
several devices, connect the jack POWER OUT to the input POWER IN of the next unit until all units are
connected. Matching power cables with IEC plugs and IEC inline jacks are available as accessory. A
maximum of 8 units can be linked.
DMX512 Control
The unit is equipped with 3-pin XLR connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2
Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain.
Always connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection
Summary of Contents for LED KLS
Page 23: ...www eurolite de 23 KONFORMITÄT ...
Page 43: ...www eurolite de 43 NOTES ...
