00079552.DOCX, Version 1.1
18/20
Procedure:
Step 1:
On the baseplate, there are holes for the installation.
Step 2:
Hold the baseplate onto the location where the device is to be installed.
Step 3:
Mark the boreholes with a pen or a suitable tool.
Step 4:
Drill the holes.
Step 5:
Hold the baseplate in the desired position and tighten it.
Connection with the mains
Connect the device to the mains with the power plug. Thus it is powered on. By disconnecting the device
from the mains it can be switched off.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Inserting a battery into the remote control
1
The remote control of the audio player is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during storage. Prior to the
first operation remove the foil from the battery support on the rear side of the remote control. Otherwise
operation of the remote control is not possible.
If the range of the remote control decreases (3 meters as a maximum), replace
the battery. For this purpose, on the rear side of the remote control press the
small bar with the groove to the right and at the same time remove the battery
support.
2
If the device is not used for a longer period (approx. 1-2 weeks), please remove the battery to prevent
damage in case of battery leakage.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
not be disposed of with regular domestic waste!
