00128029, Version 1.0
25/36
Mounting on a stand
For mobile use, place the light set on a stand via the sleeve and fasten the fixation
screw. Suitable stands can be found in chapter Accessories.
Notes:
•
Please make sure the load is installed in a balanced way and the carrying
capacity of the stand is not exceeded.
•
Install the stand on a plane area (inclination angle max. 5°) and out of the reach
of people.
•
Depending upon the individual installation spot, all necessary measures to
prevent displacement or tilting (also in case of fire) have to be taken.
CONNECTIONS
DMX512
control
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Wireless DMX transmission with QuickDMX
The device features an alternative DMX input for a QuickDMX receiver (sold separately). This connector
allows for wireless transmission of DMX control signals to the device. The connector is designed as a USB
port which provides the required 5 V operating voltage for the receiver. With QuickDMX devices, extensive
cabling between the DMX controller and the device is not required.
Occupation of the USB port:
Device 1
Start Address 1
Device 2
Start Address 20
Device 3
Start Address 41
DMX Controller
Program
Chase32 Step100
Summary of Contents for KLS-120
Page 2: ......
