00121118, Version 1.0
25/32
Control Board
The Control Board offers several features: you can easily set the starting address or select a DMX channel
mode.
The main menu is accessed by pressing Menu. Browse through the
menu by pressing Up or Down. Press Enter in order to select the
desired menu. You can change the selection by pressing Up or Down.
Press Enter in order to confirm. You can leave every mode by
pressing Menu. The functions provided are listed in the following sections.
Default settings shaded.
Menu
level 1
Menu level 2
Description
Addr
d001-d512
DMX address setting
CHnd
2CH, 3CH, 4CH
Setting DMX channel mode
FLAS
00-99
Strobe effect
00-99 (with increasing speed)
UL--
000-255
Dimmer intensity
000 – 255 (increasing)
gobo
000-255
Gobo rotation
000-255 (with increasing speed)
LEd
10/30/60/90
Display shutoff
Shuts off the display after about 10, 30, 60 or 90 seconds
nodE
off-dIn4
Dimmer speed (step response)
off: Response characteristics of LEDs
dIn1: Response characteristics of halogen lamps, fast
dIn2: Response characteristics of halogen lamps, less fast
dIn3: Response characteristics of halogen lamps, middle
dIn4: Response characteristics of halogen lamps, slow
POU-
HI/low
Power-save mode
low - power save mode, 50 % power
HI - full power
LOC
on/off
Lock and unlock the keys of the control board/touchscreen
In order to deactivate the keylock function, press the keys ENTER and
DOWN at the same time.
VErn
VEX.X
Firmware version
rest
yes/no
Restore factory settings
All settings will be set back to the default values (shaded).
EUROLITE IR-13 remote control
1
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
2
The remote control is supplied with a battery inserted. An insulating foil between
the battery and the battery contacts prevents the battery from being discharged
during storage. Prior to the first operation remove the foil from the battery
support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
3
If the range of the remote control decreases (10 meters
as a maximum), replace the battery. For this purpose,
on the rear side of the remote control press the small
bar with the groove to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR2032 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
MENU
ENTER
UP
DOWN
