Troubleshooting
8 - 10 Display
8
The screen is flickering,
or the images aren’t
clear.
The vertical refresh rate is insufficient on your external monitor.
Avoid using the
Simultaneous display mode. Use LCD only or external monitor only. Switch to a lower
resolution and/or fewer colors, and adjust the refresh frequency in the display controls (see
“Vertical Refresh Rate” on page 3 - 10
).
The viewing angle of the LCD is bad.
Adjust the position of the LCD. LCD’s are designed
to be viewed “straight on”. If the angle is wrong, you may see glare from the screen’s
backlight.
The screen is dirty.
Clean the screen using a soft, clean
dry
cloth. Many cleaning solutions
can damage the LCD surface so you should follow the precautions outlined in the
Preface
.
Try to avoid touching the screen itself. Even the cleanest hands can leave oils which
attract contaminants.
No image appears on the
external monitor I have
plugged in and powered
on.
You haven’t used the key combination to switch the display options.
Press the
Fn + F6
key
combination to toggle through the options.
You haven’t installed the video driver and configured it appropriately from the
Control
Panel
.
See
“What to Install” on page 4 - 2
for instructions on installing the driver, and
see
“Making Adjustments for the Display” on page 3 - 4
for instructions on configuring
the video driver.
Problem
Possible Cause - Solution
Summary of Contents for M375C MILANO
